Jetting 03 crf 150f
  • ronbass
    Posts:1
    Joined:Fri Jun 16, 2017 9:56 am
    Jetting 03 crf 150f

    by ronbass » Fri Jun 16, 2017 10:20 am

    I just installed the power up kit in 03 crf150f with 115 main and the bike starts fine but will not even rev up at all. It has FMF exhaust with snorkel removed from air box.Tried adj a/f mixture . Any suggestions would be greatly appreciated. Trying to get it going so my son can ride this weeken
  • Aussiecrf230
    Posts:1964
    Joined:Fri Jan 06, 2006 11:11 pm

    Re: Jetting 03 crf 150f

    by Aussiecrf230 » Fri Jun 16, 2017 8:20 pm

    Did it start and run fine before you changed jetting?
    What position did you put new needle?
    How old is fuel and spark plug?
    Breather tubes not kinked?
    Is the plug lead on properly,can get displaced when pulling tank off to get to carby.

    Hope that helps
    Ray
    Australia

    CRF230F 2004
    C30F Power Up needle
    Mains 132
    Idle 45
    2 turns out
    Baffle out, Screens In

    It starts,it runs,it gets to where all CRFs can get to without the valve or valve plate dramas

Who is online

Users browsing this forum: No registered users and 3 guests