ADR speedo sensor location
  • Krohny84
    Posts: 2
    Joined: Mon Nov 09, 2020 4:54 am

    ADR speedo sensor location

    by Krohny84 » Tue Nov 10, 2020 1:56 am

    I'm stuck on where to mount the sensor at the rear wheel on my 2008 250x for the original digital speedo, if someone could point me in the right direction or even post a picture of theirs it would be much appreciated.

    Thanks in advance!
  • User avatar
    JimDirt
    Posts: 4406
    Joined: Sat Nov 25, 2006 6:31 pm

    Re: ADR speedo sensor location

    by JimDirt » Tue Nov 10, 2020 1:25 pm

    Welcome to the site !! \:D/

    The Aus bikes are different than the U.S. models , hopefully Ray will chime in and have a idea where it goes ..... the 08 X's over here use a speedo cable and a mechanical trip meter on the front wheel hub ..... 8-[ :-k
    2020 CRF450R
    2006 CRF450X
    Image
    Weiser , Idaho
  • Aussiecrf230
    Posts: 1962
    Joined: Fri Jan 06, 2006 11:11 pm

    Re: ADR speedo sensor location

    by Aussiecrf230 » Tue Nov 10, 2020 1:57 pm

    I thought they were all on the front wheel too, on right hand side.
    Have to try remember who did adr electrics, LOL.
    Probably best I look it up. May have a picture.

    If there is no obvious place at the front wheel then a previous owner may have changed the bushings to delete it. Does happen from time to time.
    Ray
    Australia

    CRF230F 2004
    C30F Power Up needle
    Mains 132
    Idle 45
    2 turns out
    Baffle out, Screens In

    It starts,it runs,it gets to where all CRFs can get to without the valve or valve plate dramas
  • Krohny84
    Posts: 2
    Joined: Mon Nov 09, 2020 4:54 am

    Re: ADR speedo sensor location

    by Krohny84 » Tue Nov 10, 2020 7:18 pm

    Thanks for the welcome!

    The mechanical pick up was on the front wheel (was on there when I bought the bike) and went to the competition odometer but I have taken it off to put the original ADR speedo back on, I believe it picks up the signal from the bolts in the rear disk but I'm still not sure exactly where to mount it
  • Aussiecrf230
    Posts: 1962
    Joined: Fri Jan 06, 2006 11:11 pm

    Re: ADR speedo sensor location

    by Aussiecrf230 » Thu Nov 12, 2020 6:41 pm

    What brand is the adr speedo, it did change at some point I think.

    Acewell was brand I believe. ACE-1500 unit, is this what you have?
    Ray
    Australia

    CRF230F 2004
    C30F Power Up needle
    Mains 132
    Idle 45
    2 turns out
    Baffle out, Screens In

    It starts,it runs,it gets to where all CRFs can get to without the valve or valve plate dramas

Who is online

Users browsing this forum: No registered users and 2 guests