CRF 150F - Needle jet removal question
  • cpsmith835
    Posts: 1
    Joined: Fri Jul 13, 2018 5:43 pm

    CRF 150F - Needle jet removal question

    by cpsmith835 » Fri Jul 13, 2018 5:49 pm

    2009 CRF150F, Got the Power Up kit, put in a new main jet and pilot jet and the needle with the clip in the 4th position, all easy. But I noticed the Power Up kit came with a needle jet, which I have never messed with. How do you remove that? Looks easy to mangle, something I do well.

    Is not putting that in a terrible thing?

    Thanks
  • Aussiecrf230
    Posts: 1964
    Joined: Fri Jan 06, 2006 11:11 pm

    Re: CRF 150F - Needle jet removal question

    by Aussiecrf230 » Fri Jul 13, 2018 5:56 pm

    You undo the main jet holder and gently tap out from above with a plastic biro body. See here https://www.crfsonly.com/forum/viewtopi ... 32&t=43162.
    Ray
    Australia

    CRF230F 2004
    C30F Power Up needle
    Mains 132
    Idle 45
    2 turns out
    Baffle out, Screens In

    It starts,it runs,it gets to where all CRFs can get to without the valve or valve plate dramas
  • mustangnut
    Posts: 22
    Joined: Sun Jan 28, 2018 11:04 am

    Re: CRF 150F - Needle jet removal question

    by mustangnut » Wed Jul 18, 2018 6:16 am

    You can also use a golf tee. Drop through top of the carb so the tip rests in the hole of the needle jet. Give it a slight tap and the needle jet should fall free through the bottom. That worked in my case.

Who is online

Users browsing this forum: No registered users and 1 guest