CRF's Only Forums

Trying to reduce the lag outta the corners. Installed a new fuel screw. My shop said to turn it all the way in until it stalls, then creep it out 1/4 turn. I cranked it in all the way, it didn't stall:)

Stock is 1 1/4 turns. I read somewhere a good setting to decrease the lag is 2 turns. What about the idle? Any advice?

Thanks,

Chuck

Here you go this should help
http://www.crfsonly.com/forum/viewtopic ... #119477url

Thank you djh, thank you ~, that's exactly the info I needed.

Chuck