CRF's Only Forums

This message board is dedicated to Honda's CRF 4-Stroke Dirt Bikes.
https://crfsonly.com/forum/

Pro Circuit +4mm Handlebar Mount???????

https://crfsonly.com/forum/viewtopic.php?f=37&t=12324

Page 1 of 1

Pro Circuit +4mm Handlebar Mount???????

Posted: Wed Feb 14, 2007 8:09 pm
by hardluck
Can someone help my confusion? I have a 2005 CRF250R and i am trying to install the Pro Circuit Handlebar Mount. Currently installed is RG3 Triples with Pro Taper Contours / Pro Taper Oversize mount kit. The triples have four bolt holes on top and the pro taper mount bolts up to all four holes. This is where I got confused..... the Pro Circuit Mount only has Two studs. The package says its for my bike. Does anyone have any advice or has done this before?

Posted: Wed Feb 14, 2007 8:33 pm
by Asmith
Pro Circuit's website doesn't list +4mm Bar Clamps for the RG3 Triple clamps.

They all say for Pro Circuit Triple Clamps.

Does the package say they are for RG3 Triples???

Posted: Thu Feb 15, 2007 9:10 pm
by hardluck
No and that is my problem i am finding out
All times are UTC-07:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/