CRF's Only Forums

Hi
I've snapped one of my cylinder bolts before it's reached its torque setting.
This was unfortunate enough but has been compounded by the lack of spares anywhere in Europe!
It's the bolt B (90032-KFB-000) that's broke, is this a common problem?
The bolt is readily available in the states and Australia but getting it shipped seems to be a headache.
Most USA stockists don't seem to ship to the UK and the ones that do are out of stock.
Has anyone got any advice of where to source a pair or a full set?
Bolt A seems readily available.
I'm UK based BTW.
Cheers

Shaw

I would check out the OEM parts link here on the site and check it out. I am sure Ken will send what you want to you. If you don't see what you want in the diagrams shoot Ken a note.

Where did the stud break?

Would be pretty unusual unless it was subjected to a sideways for force that has put stress at bottom of thread root.

I would get a complete set to be safe.

Thanks for the replies. I have two full sets on order now, both from the USA. One set via eBay where a nice guy went out of his way to get set to me, they are sitting in a UK sorting office at the moment. Another new set on the way too (hopefully), no word on those. Fairly sure the failure was due to a torque wrench being way out of calibration. It is the click type, I didn't know they could go so far out of calibration. No other damage done but the bike being out of action at the end of of our Covid lockdown is gutting.