CRF's Only Forums

I want to remove the retaining clip that hold the shifter plate on but I don't know the correct size pliers to buy. I know the actual retainer clip is a 12mm from the info I found but what size are the holes? I checked the local auto parts website and they list it by the hole size like .070, .038 etc. Anyone have any ideas what size will fit the tiny holes?

i don't know the actual size. however, look for a set like this with several to choose from:

http://www.crfsonly.com/catalog/product ... ts_id/2528



ken

Thanks for the info Ken. I saw this type on a website of an autoparts store down the street from me. Maybe I should try something like that. I guess I have nothing to lose and everything to gain. At least I'll have a variety to choose from. One of them should fit I would think.

also, if it's a bit tight you can always file it down with a file or sandpaper...been there done that!

Picked up one of these today on the way in to work. $14.99 (plus tax of course). Almost exactly like the one shown. Thanks again for the help. I'll try it out tomorrow...