by Aussiecrf230 » Tue Dec 10, 2019 2:30 am
I am pretty sure the float bowl is a neoprene ring not a gasket.
Assume you just changed those jets out.
Perhaps the bowl has been off to many times or there is something not letting the bowl properly seal the ring.
I would take off the bowl and see if the oring is sitting proud of the bowl.
Check the bowl fit properly as you put it on as it can get hung up on the overflow tube.
I would check for a bit of trash in the needle and seat while you are in there.
Be careful you don't lose the needle or the pin.
Ray
Australia
CRF230F 2004
C30F Power Up needle
Mains 132
Idle 45
2 turns out
Baffle out, Screens In
It starts,it runs,it gets to where all CRFs can get to without the valve or valve plate dramas