I looked through many past posts but found no definitive info on jetting for a CRF100F. Most stock bikes are jetted lean from the factory thus requiring a re-jet. Add to the mix that the 2007 CRF100F I just bought for my son has an FMF pipe/muffler ... and the engine will be even leaner. Thus, does anyone have any jetting advice?
So far this is what I have learned.
Stock main jet = 98 (99101-GHB-0980)
Stock slow jet = 35 (99104-KN4-0350)
Stock needle = non-adjustable clip height (16012-KSJ-A01)
Stock air bleed = 1.5 turns out from seated (16016-KSJ-A01)
Internet research shows that others are running:
Main jet = 102 to 115 (that's a pretty wide range!)
Slow jet = 37 to 40 (again, that's a fairly wide range)
Needle = no info on a different (better) needle
Air bleed = some say to go 2.5 turns out
Thus, if I average all the numbers it would indicate a ballpark setup of:
Main jet = around 108 (99101-GHB-1080)
Slow jet = around 38 (99103-KA9-0380)
Air bleed = around 1.75-2 turns out (16016-KN4-L10; adjustable screw from 2004 CRF100F)
However, does anyone have any more tried and true jetting info to offer ... especially for a CRF100F with aftermarket exhaust?