jetting
  • User avatar
    zak13
    Posts: 955
    Joined: Tue Apr 03, 2007 4:58 pm

    jetting

    by zak13 » Sun Aug 26, 2007 10:20 am

    if my carb is stock with the fuel screw 2 turns out if i move my needle to the 4th position will i have to get whole new jets or can i get away with just doing that
    sellin my xr100
    Image
  • User avatar
    Skoot22
    Posts: 2380
    Joined: Sun Sep 03, 2006 9:51 pm

    by Skoot22 » Mon Sep 03, 2007 10:04 pm

    you can just do that.
    Scott
    05 CRF450X
    Bakersfield, Ca
    Image
  • User avatar
    zak13
    Posts: 955
    Joined: Tue Apr 03, 2007 4:58 pm

    by zak13 » Tue Sep 04, 2007 5:59 am

    okay thanks and how do i remove the clip from the needle
    sellin my xr100
    Image
  • Asmith
    Posts: 14381
    Joined: Mon Apr 10, 2006 7:52 am

    by Asmith » Tue Sep 04, 2007 6:06 am

    zak13 wrote:okay thanks and how do i remove the clip from the needle


    Needle nose pliers.
  • User avatar
    zak13
    Posts: 955
    Joined: Tue Apr 03, 2007 4:58 pm

    by zak13 » Tue Sep 04, 2007 1:37 pm

    i tried and it wont come off
    sellin my xr100
    Image
  • User avatar
    Skoot22
    Posts: 2380
    Joined: Sun Sep 03, 2006 9:51 pm

    by Skoot22 » Wed Sep 05, 2007 12:26 am

    lay the needle down on a hard flat surface and push the needle down from the top just above the clip so you dont bend it, with the open side of the c-clip facing down toward the surface, it should pop right off. Dont lose it. and do the same to get it back on, open side of clip facing up of course. Or use pliers to get it back on.

    Scott
    Scott
    05 CRF450X
    Bakersfield, Ca
    Image

Who is online

Users browsing this forum: No registered users and 2 guests